MultiCom Technical Support Forum Index MultiCom Technical Support
Supporting MultiCom Routers, Firewalls and VPN
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

I just saved my configuration and the Firewall is rebooting?

 
Post new topic   Reply to topic    MultiCom Technical Support Forum Index -> 3.x Frequently Asked Questions
View previous topic :: View next topic  
Author Message
Support



Joined: 09 Oct 2002
Posts: 175
Location: Lausanne, Switzerland
PostPosted: Wed Oct 09, 02 17:52    Post subject: I just saved my configuration and the Firewall is rebooting? Reply with quote
There is something in your configuration file that is causing your MultiCom Firewall to reboot. First restore the default configuration and then look at the changes you have made.

The default configuration can be restored by holding down the "config" button of the MultiCom Firewall during rebooting, be sure to continue to hold the button until the leds have stopped blinking.

The only known configuration that causes reboots is if you have configured the MISC>NAT "To Address" field to have an ip address such as 10.0.0.1/32. Simply remove the "/32" and resave the configuration file. This problem is known for firmware versions 3.0, 3.01, 3.1 and is corrected in version 3.2 and later.
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    MultiCom Technical Support Forum Index -> 3.x Frequently Asked Questions All times are GMT + 1 Hour
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group